Plate Mill

Mill Balance

The set of 4 [check] cylinders that take the pressure off the screws, in effect prevent (I'm assuming) metal to metal while adjusting the mill and also when rolling.

Roll Bending

The work rolls are bent up into the backup rolls to give a non parallel gap between the work rolls, such that the centres are closer together than the ends.

Backup Roll Bending [check]

Roll Tapers [check]

Check if it's both the work rols and backup rolls.

Pass Line

35mm, the bottom work roll sits higher than the breast roller table.

The breast roller table, I belive pivots and is adjusted at the front with packers.